Lorick Spray Foam Solutions

The people you work with are so nice and easy to work with! they make the process so easy. The prices can not be beat! highly recommend will use them again!!

Saw this company through Facebook and messaged about a quote. Response time was great! Would definitely recommend Lorick Spray Foam Solutions.

Cheap, and you get what you pay for.

Got my pride and joy bus conversion that I’ve put well over 1500 hours of work into spray foamed and I’m pretty disappointed.

I went with Lorick because the other contractor I had booked out a month in advance screwed me over. I was just happy to have someone do it because my time frame was limited. I had to drive 3 hours round trip to Pontotoc, because he wouldn’t make the trip for a “small job”. I arrived at 10:30 as suggested and the owner isn’t even there, he’s in Oxford doing something, and the employee hadn’t changed over from open to closed cell so I literally stood around until 11:30 for him to start. Employee was nice but honestly he didn’t do a great job. I covered all the windows myself and they came out clean. However every other surface that shouldn’t have spray foam on it got sprayed. He made basically no effort to avoid overspray. My windshield, my nice air ride seat, engine compartment door, switch panel, tool box, solar combiner box, the entire floor, and outside of the bus and tire all have foam on them which I will now have to spend probably dozens of hours removing with a wire brush.

In addition, the application of the foam was not at all uniform. There were areas where it stuck out a half inch past my wood furring strips and others where I could still see the metal of the bus. I also specifically asked about needing to further tape down the wires to avoid them being pushed out by the foam and he said that wouldn’t be necessary as he could hold them down and spray on top. Of course, they got pushed out, and I’m having to figure out a way to deal with that to get my walls up.

Owner also said they don’t trim the foam because you “can’t shave closed cell” which is just a lie because it cuts with any saw or a scraper as I’ve been doing all day. I think what he actually meant is that it’s going to be so messy that we’d have to spend 3 times as long cleaning and trimming.

After the job was “done” I was given a price by the employee above what I was quoted on the phone, and I called the owner to discuss my issues with the job and the price, and he ignored all of my calls even though he had just answered his employee’s call to give a price and I still haven’t heard back. I can only assume that he’s aware of the poor quality work he’s responsible for and doesn’t want to address it.

All in all it’s foamed, and will probably do a good job insulating, but it’s not as clean and uniform as I expected, and at the rate it’s going I anticipate many days of cleaning up in addition to a full day or two of trimming down the foam itself so I can get my walls and ceiling to fit flush. Can not recommend.